Luggage / Roof Rack: Service and Repair

Roof Rail Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program, 888-424-6857

For Some Models

NOTE:

- Take care not to scratch the covers, the roof rail, or the body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When using a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Pry up on the front cover (A) with a trim tool to detach the clips and rib (B) from the front bracket (C), then remove the cover by pulling the cover forward.






2. Pry up on the rear cover (A) with a trim tool to detach the clips from the rear bracket (B), then remove the cover by pulling the cover rearward.






3. Remove the roof rail (A) and the center bracket (B).

1. Using a trim tool, pry the notch (C), then remove the roof rail bar cap (D).

2. Using a TORX T30 bit, remove the nuts (E) from the front bracket (F) and the rear bracket (G).

3. Using a TORX T30 bit, remove the bolts (H), then remove the roof rail.

4. Remove the center cover (I), and using a TORX T30 bit, remove the nuts (J), then remove the center bracket.





4. Install the roof rail in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.