Rear Fuse/Relay Box Removal/Installation

Rear Fuse/Relay Box Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations Locations, precautions and procedures Service and Repair before doing repairs or servicing.

Removal

1. Do the battery terminal disconnection procedure, and wait for at least 3 minutes.

2. Remove the left rear side trim panel Interior Trim Removal/Installation - Rear Side Area.

3. Disconnect the connectors from the rear fuse/relay box (A).





4. Remove the mounting nuts and the rear fuse/relay box.

5. Carefully remove the relays by prying under the base of the relay.

NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start or cause other functions to fail.

Installation

1. Install the relays and connect the connectors to the rear fuse/relay box, then install the rear fuse/relay box in the reverse order of removal.

2. Install the removed parts in the reverse order of removal.

3. Do the battery terminal reconnection procedure.

4. Confirm that all systems work properly.