A/T Clutch Pressure Control Solenoid Valve A, B, C, and D Test

A/T Clutch Pressure Control Solenoid Valve A, B, C, and D Test

1. Connect the HDS to the DLC (A) located under the driver's of the dashboard.





2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting Testing and Inspection.

3. Select Clutch Pressure Control (Linear) Solenoid Valve A, B, C, or D in the Miscellaneous Test Menu with the HDS.

4. Test A/T clutch pressure control solenoid valve A, B, C, or D with the HDS.

- If the valve tests OK, the test is complete. Disconnect the HDS.
- If the valve does not test OK, follow the instructions on the HDS.
- If the valve does not test OK, and the HDS does not determine the cause, go to step 5.

5. Do the battery removal procedure Removal and Replacement.

6. Remove the main under-hood fuse box from the battery base.

7. Remove the intake air duct and the air cleaner housing.

8. Remove the battery base and the battery base bracket.

9. Disconnect the A/T clutch pressure control solenoid valve A, B, C, or D connector.





10. Measure the resistance between A/T clutch pressure control solenoid valve A, B, C, or D connector terminals No. 1 and No. 2.





- If the resistance is out of the standard, replace the secondary valve body Secondary Valve Body Replacement.
- If the resistance is within the standard, go to step 11.

11. Connect a jumper wire from the negative battery terminal to solenoid valve A, B, C, or D connector terminal No. 2, and connect another jumper wire from the positive battery terminal to connector terminal No. 1.

- If a operating sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
- If no operating sound is heard, replace the secondary valve body Secondary Valve Body Replacement.

12. Install the battery base bracket and the battery base.

13. Install the air cleaner housing and the intake air duct.

14. Install the main under-hood fuse box on the battery base.

15. Do the battery installation procedure Removal and Replacement.