Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front seat Front Seat Removal/Installation.

3. Remove the lower B-pillar lower trim panel Interior Trim Removal/Installation - Pillar Areas.

4. Disconnect the floor wire harness 4P connector (A) from the side impact sensor (first) (B).






5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the side impact sensor (first).

Installation

1. Install the side impact sensor (first) (A) with a new TORX bolt (B) using a TORX T30 bit, then connect the floor wire harness 4P connector (C) to the side impact sensor (first).





2. Do the battery terminal reconnection procedure Procedures.

3. Clear any DTCs with the HDS.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then goes off.

5. Install the parts in the reverse order of removal.