Seat Position Sensor: Service and Repair
Driver's Seat Position Sensor Replacement
Removal
NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Raise the seat all the way up.
2. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.
3. Remove the driver's seat Front Seat Removal/Installation.
4. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).
5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor.
Installation
NOTE:
- Be sure to install the harness wires so they are not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
1. Install the driver's seat position sensor (A) with a new TORX bolt (B) using a TORX T30 bit, then connect the driver's seat wire harness 2P connector (C) to the driver's seat position sensor.
2. Install the driver's seat Front Seat Removal/Installation.
3. Do the battery terminal reconnection procedure Procedures.
4. Clear any DTCs with the HDS.
5. Check the operation of the driver's seat position sensor with the HDS Driver's Seat Position Sensor Operation Check.
6. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then goes off.