B1555

DTC Troubleshooting: B1555

DTC B1555:

Automatic Lighting Control Unit Lost Communication With the MICU (HLSW Message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Check for DTCs with the HDS.

Is DTC B1155 also indicated with B1555?

YES -

Go to MICU input test Exterior Lights (MICU) Input Test.

NO -

Go to step 5.

4. Turn the ignition switch to ON (II).

5. Measure the voltage between the automatic lighting control unit 14P connector terminals No. 1 and No. 8, and terminals No. 7 and No. 9 respectively.





Is there battery voltage?

YES -

Replace the automatic lighting control unit.

NO -

Repair an open or high resistance in the wire, a blown No. 36 (10 A) fuse or No. 10 (7.5 A) fuse in the under-dash fuse/relay box. If the fuse blows again, repair a short to ground in the No. 36(10 A) fuse or No. 10(7.5 A) fuse circuits, or poor ground (G602).