Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front bumper Service and Repair.

3. Disconnect the engine compartment wire harness 2P connector (A) from the front impact sensor.





4. Remove the TORX bolts (B) using a TORX T30 bit, then remove the front impact sensor (C).

Installation

1. Install the front impact sensor (A) with new TORX bolts (B) using a TORX T30 bit, then connect the engine compartment wire harness 2P connector (C) to the front impact sensor.





2. Do the battery terminal reconnection procedure Procedures.

3. Clear any DTCs with the HDS.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go off.

5. Reinstall all removed parts.