Seat Temperature Switch: Service and Repair

Seat Heater Switch Test/Replacement

1. Remove the center console panel and audio pocket Center Console Removal / Installation.

2. Disconnect the 6P (or 7P*) connector from the seat heater switch (A), then remove the switch.

*: Front passenger's






3. Check for continuity between the terminals in each switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Note this important operation characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).





4. If the continuity is not as specified, replace the switch.