A/T Housing Reverse Idler Gear Disassembly/Inspection/Reassembly

A/T Housing Reverse Idler Gear Disassembly/Inspection/Reassembly

1. Remove the snap ring (A), then remove the thrust washer (B), the reverse idler gear (C), the needle bearings (D), and the thrust washer (E) from the reverse idler gear shaft/holder (F).





2. Inspect the reverse idler gear and gear shaft for excessive wear and damage.

3. Inspect the needle bearings for galling and rough movement.

4. Install the thrust washer and the needle bearings over the gear shaft.

5. Install the reverse idler gear in the direction shown.

6. Install the thrust washer, then install the snap ring to secure the idler gear.