Transfer Output Shaft (Hypoid Gear) Bearing Removal/Installation (SH-AWD)

Transfer Output Shaft (Hypoid Gear) Bearing Removal/Installation

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the tapered roller bearing (A) from the transfer output shaft (hypoid gear) (B) using a bearing separator (C) and a press. Place a spacer (D) between the transfer output shaft (hypoid gear) and the press to prevent damaging the transfer output shaft (hypoid gear).






2. Install the 40 mm thrust shim (A) over the transfer output shaft (hypoid gear) (B).





3. Install the tapered roller bearing (C) over the transfer output shaft (hypoid gear) using the driver handle (40 mm I.D.) and the press.