Interior Light Switch Test/Replacement

Interior Light Switch Test/Replacement

1. Pull down the roof console (A) holding the center part of the roof console.





2. Disconnect the 20P connector (B) from the roof console.

3. Check for continuity between the terminals in each interior light switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Note this important operating characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).





4. If the continuity and the diode bias is not as specified, replace the roof console as an assembly.