Failure Mode F

Mode F: SRS No.10 fuse open.


CAUTION : Disconnect both the negative and positive battery cables. Connect the short connector to the airbag assembly - refer to "Indicator Light Troubleshooting", caution notice.

1. Check the No. 10 (10 A) fuse in the dash fuse box.

- If No.10 (10 A) fuse is OK, go to step 2.

- If blown, replace the No. 10 (10 A) fuse and recheck the voltages according to the chart in the "Indicator Stays On Continuously" procedure.

2. Reconnect the battery cables, then connect the SRS test harness B to the main harness's 12-P connector. Measure the voltage between the B6 terminal and body ground (with ignition switch ON).






SRS Test Harness

- If there is battery voltage, the SRS unit is faulty; replace and recheck the voltages according to the chart in the "Indicator Stays On Continuously" procedure.

- If less than battery voltage, the main harness is faulty; replace the SRS main wire harness and recheck the voltages according to the chart in the "Indicator Stays On Continuously" procedure.