Campaign - Ignition System Igniter: Overview

September 7, 1993

BULLETIN NO.
93-019

YEAR
1989-90

MODEL
LEGEND

VIN APPLICATION
ALL

Product Update: Legend Igniter

BACKGROUND

The igniter may fail. If this happens, the engine will not start. This product update is being conducted to help eliminate any possibility of igniter failure.

CUSTOMER NOTIFICATION

Owners of affected vehicles will be contacted by mail and asked to take the car to a dealership for repair. The text of the customer letter is at the end of this service bulletin.

CORRECTIVE ACTION





Replace the igniter with the updated part listed under PARTS INFORMATION.

1. Inspect the igniter mounted on the left inner fender panel.

^ If the mounting bolts go through the heat sink, it is not an updated igniter. Continue with this replacement procedure.

^ If the mounting bolts go through the igniter body, it is an updated igniter. Go to step 6.

2. Disconnect the 4-pin igniter connector.

3. Remove the igniter mounting bolts and the igniter. Discard the bolts and the igniter.

4. Connect the 4-pin connector to the new igniter.

5. Install the igniter with the new bolts that came in the kit. Torque the bolts to 10 Nm (1.0 kg-m, 7 lb-ft).





6. Center-punch a completion mark above the "H" in the engine compartment VIN.

PARTS INFORMATION

Igniter Kit: P/N 06302-PL2-H00

WARRANTY CLAIM INFORMATION

Operation Flat Rate
Number Description Time

117535 Inspect igniter only, no 0.2 hour
replacement

117135 Inspect and replace 0.2 hour
igniter

Failed P/N: 30120-PL2-014

Defect code: 625

Contention code: J73