Preparation

CAUTION:
- Before testing, be sure the transmission is filled to the proper level.
- Connect an oil pressure gauge securely, being sure not to allow dust and other foreign particles to enter the inspection hole.
- Warm up the engine before testing.
- Set the parking brake securely. and block both rear wheels.
- Raise the front of the car and support with safety stands.

NOTE:
- Do not reuse old aluminum washers. Install the sealing bolt in the inspection hole and tighten to the specified torque 18 Nm (1.8 kg-m, 12 lb-ft).

1. Stop the engine and connect a tachometer.

2. Connect an oil pressure gauge to each inspection hole.

3. Start the engine and measure respective pressures as follows.