Without Scan Tool

ENGINE CONTROL MODULE (ECM) RESET PROCEDURE
1. Turn the ignition switch off.
2. Remove the BACK UP (7.5 Al fuse from the under-hood fuse/relay box for 10 seconds to reset the ECM.
CANADA: Remove the HAZARD, BACK UP (10 A) fuse from the under-hood main fuse box for 10 seconds to reset ECM.

FINAL PROCEDURE (This Procedure Must Be Done After Any Troubleshooting)
1. Remove the Jumper Wire.

NOTE: If the Service Check Connector is jumped, the MIL will stay on.

2. Do the ECM Reset Procedure.