Anti-Lock Brake With (ALB) Checker

Air Bleeding with ALB Checker
1. Disconnect the 6-P inspection connector (PNK) from the connector cover located under the glove box and connect the 6-P inspection connector to the ALB checker.

CAUTION: Place the vehicle on level ground with the wheels blocked. Put the transmission in neutral for manual transmission models, or in (P) range for automatic transmission models.

2. Fill the modulator reservoir to the MAX level line.

NOTE: Do not reuse aerated brake fluid that has been bled from the power unit.






3. Bleed high pressure fluid from the maintenance bleeder with the special tool.
4. Start the engine and release the parking brake.

NOTE: Depress the brake pedal firmly while test in progress light in ON.

5. There should be at least two strong kickbacks. If not, repeat steps 2 through 5, as necessary.






6. Fill the modulator reservoir up to the MAX level line.
7. Install the reservoir cap.
8. Check the anti-lock brake system function in all modes by using the ALB checker.