Transmission Housing

TOOLS REQUIRED
* 07HAC-PK4010A Housing Puller
* Or Equivalent





NOTE:
* Clean all parts thoroughly in solvent or carburetor cleaner, and dry with compressed air.
* Blow out all passages.
* When removing the transmission housing, replace the following:
- O-rings
- Transmission housing gasket
- Connector holder

1. Disconnect the mainshaft and countershaft speed sensor connectors.
2. Remove the connector holder and connector brackets.
3. Remove the countershaft speed sensor and mainshaft speed sensor from the transmission housing.
4. Remove the ten bolts securing the transmission housing, then remove the 10 mm bolt and three 8 mm bolts securing the transmission housing to the torque converter housing side;





5. Install the special tool on the transmission housing, then remove the transmission housing as shown.

CAUTION: Make sure that the mainshaft and countershaft speed sensors have been removed from the transmission housing before removing the transmission housing from the torque converter housing.





6. Remove the mainshaft sub-assembly and countershaft sub-assembly together.

NOTE: When removing the shafts, take care to prevent damage to the regulator valve body.

7. Remove the secondary driven gear shaft from the torque converter housing.