DTC List - Transmission Control

(DTC)*: The DTCs in the parentheses are the number of the (D4) indicator light blinks when the service check connector is connected with the special tool (SCS service connector).

NOTE:
- When the OBD II Scan Tool or Honda PGM Tester indicates the DTC(s) for the automatic transmission control system, the scan tool or tester also indicates code P0700 simultaneously. Code P0700 means detection of some automatic transmission problem on the PGM-FI control system.

If the self-diagnostic (D4) indicator light does not blink, perform an inspection according to the table below.

NOTE:
- If a customer describes the symptom for code P1706 (6), PO725 (11) or P0715 (15), it will be necessary to recreate the symptom by test-driving, then recheck the DTC.
- Sometimes the (D4) indicator light and the Malfunction Indicator Lamp (MIL) may come on simultaneously. If so, check the PGM-FI system according to the DTC, then reset the memory by removing the BACK UP fuse in the under-dash fuse/relay box for more than 10 seconds. Drive the car for several minutes at a speed over 30 mph (50 km/h), then recheck the DTC.
- Disconnecting the BACK UP fuse also cancels the radio anti-theft code, preset stations and the clock setting. Get the customer's code number, and make note of the radio presets before removing the fuse so you can reset them.