Manual Transmission

BACK-UP LIGHTS / TEST (MANUAL TRANSMISSION)

NOTE: Check the No. 15 (10 A) fuse in the under-dash fuse/relay box before testing.

1. Test the back-up light switch by placing the shift lever in reverse and turning the ignition switch to ON
2. If the back-up lights do not go on, check the backup light bulbs in the taillight assembly.







3. If the fuse and bulbs are OK, disconnect the connector from the back-up light switch.
4. With the shift lever in reverse, check for continuity between the A and B terminals with the switch installed.
There should be continuity.
* If there is no continuity, replace the switch.
* If there is continuity, but the back-up lights do not go on, check for:
- Poor ground (G503)
- An open in the wire