Maintenance Reminder Unit Resetting

MAINTENANCE REMINDER UNIT / RESETTING







CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.

Whenever the ignition switch is ON, or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

For additional precautions, refer to the SRS section Service Precautions.









To reset the unit, the car must be parked and the ignition switch must be ON (II). Press the reset button ON the unit for more than 3 seconds, and the reminder light will go OFF.


NOTE:
Turn the ignition switch OFF before you remove the 5-P connector from the maintenance reminder unit, otherwise you will cancel all data in the memory.

The data will remain in the memory even when the ignition switch is turned OFF, or if the unit is disconnected. When the ignition switch is turned ON (II), and the car is driven, additional data will be stored.