Stall Speed Test

TEST

CAUTION:
- To prevent transmission damage, do not test staff speed for more than 10 seconds at a time.
- Do not shift the lever while raising the engine speed.
- Be sure to remove the pressure gauge before testing stall speed.

1. Engage the parking brake and block the front wheels.
2. Connect a tachometer to the engine, and start the engine.
3. Make sure the A/C switch is OFF.
4. After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift into [2] position.
5. Fully depress the brake pedal and accelerator for 6 to 8 seconds, and note engine speed.
6. Allow two minutes for cooling, then repeat the test in [D4], [1], and [R] positions.






NOTE:
- Stall speed tests should be used for diagnostic purposes only.
- Stall speed should be the same in [D4], [2], [1], and [R] positions.

Stall Speed RPM:
Specification: 2350 rpm
Service Limit: 2200-2500 rpm