Ignition Switch: Testing and Inspection

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Ignition Switch Test:

1. Remove the dashboard lower cover and knee bolster.
2. Remove the left front door sill molding and the left kick panel.

Ignition Switch Test:

3. Disconnect the switch harness 7P connector from the under-dash fuse/relay box.

Ignition Switch Test:

4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity checks do not agree with the table, check for a bad connection between the switch and switch harness.
^ If the connection is OK, replace the switch.
^ If the connection isn't OK, repair as necessary, and recheck. If continuity checks still do not agree with the table, replace the switch.