Reverse Idler Gear
DIMENSIONSClearance Between The Reverse Change Holder And The 5th/reverse Shift Piece Pin Standard:
Reverse Side 0.05 - 0.45 mm (0.002 - 0.018 inch)
5th Side 0.4 - 0.9 mm 10.02 - 0.04 inch)
Width Of The Grooves In The Reverse Change Holder Standard:
Reverse Side 7.05 - 7.25 mm (0.278 - 0.285 inch)
5th Side 7.4 - 7.7 mm (0.29 - 0.30 inch)
Clearance Between The Reverse Idler Gear And The Reverse Change Holder:
Standard 0.5 - 1.1 mm (0.02 - 0.04 inch)
Service Limit 1.8 mm (0.07 inch)
Width Of The Reverse Change Holder:
Standard 13.0 - 13.3 mm (0.512 - 0.524 inch)