Differential: Adjustments
TOOLS REQUIRED- 07746-0030100 Driver, 40 mm I.D.
- Or Equivalent
1. Install the differential assembly, making sure it bottoms in the clutch housing, using the special tool as shown.
2. Install the 80 mm shim.
NOTE: Install the 80 mm shim that was removed.
3. install the transmission housing.
NOTE: Do not apply liquid gasket to the mating surface of the clutch housing.
4. Tighten the transmission housing attaching bolts.
- 8 x 1.25mm: 27 Nm (20 ft. lbs.).
5. Use the special tool to bottom the differential assembly in the clutch housing.
6. Measure clearance between the 80 mm shim and bearing outer race in the transmission housing.
7. If the clearance is not within the standard, select a new 80 mm shim from the following table.
- Standard: 0 - 0.10 mm (0.004 inch).
NOTE: If the clearance measured in step 6 is within the standard, it is not necessary to go to step 9.
8. Remove the bolts and transmission housing.
9. Replace the 80 mm shim selected in step 7, then recheck the clearance.
10. Reassemble the transmission and install the transmission housing.