Installation

INSTALLATION






1. Before installing the steering wheel, center the cable reel. Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise (approximately two turns) until. The arrow make on the cable reel label points straight up.






2. Install the steering wheel.

NOTE: Be sure the steering wheel shaft engages the cable reel and canceling sleeve.

CAUTION: Do not tap on the steering wheel or steering column shaft when installing the steering wheel.

3. Attach the cruise control set/resume switches connector to the steering wheel clip.






4. Connect the horn connector.






5. Install the airbag assembly with new Torx bolts, and install the covers.






6. Hold the pawl side connector half, and press on the back of the sleeve-side connector half in the direction shown. As the two connector halves are pressed together, the sleeve is pushed back by the pawl.

NOTE: Do not touch the sleeve.






7. When the connector halves are completely connected, the pawl is released, and the spring-loaded sleeve locks the connector.






8. Attach the connector in the holder, then install the access panel on the steering wheel lower cover.
9. Connect the positive cable first, then the negative cable to the battery.
10. After installing the airbag assembly, confirm proper system operation:
a. Turn the ignition switch ON (II); the instrument panel SRS indicator light should come on for about six seconds and then go off.
b. Confirm operation of horn buttons.
c. Confirm operation of cruise control set/resume switches.