Ignition Switch: Testing and Inspection

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.

NOTE: The PCM memory must be reset after reconnecting the battery.

1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable.
3. Remove the dashboard lower cover.




4. Disconnect the 7P connector from the under-dash fuse/relay box.




5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity checks do not agree with the table, replace the electrical switch.
7. After reconnecting the battery, enter the anti-theft code for the radio and the navigation system, then enter the customer's radio station presets.