Transmission Range Switch (A/T Gear Position Switch)

Removal





1. Shift the detent lever to the P position.
2. Pry the lock tabs on the lock washer, then remove the locknut and lock washer.
3. Remove the bolts securing the transmission range switch, then remove the transmission range switch.

Installation





1. Set the transmission range switch to the N position as shown.

NOTE: The transmission range switch clicks in the N position.





2. Shift the detent lever to the N position.





3. Install the transmission range switch on the control shaft, then install the bolts loosely.





4. Install a new lock washer on the transmission range switch by aligning its projected tip with the N position mark on the transmission range switch as shown.
5. Tighten the locknut while holding the detent lever in the N position, then bend the lock tabs against the locknut.
6. Tighten the 6 mm bolts to the specified torque.