Instrument Panel, Gauges and Warning Indicators: Testing and Inspection

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in Air Bag Systems before performing repairs or service.








1. Remove the gauge assembly from the dashboard, and disconnect the 22P (C608) connector from the gauge assembly.
2. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, make the following input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the printed circuit board A must be faulty; replace it.