Ignition Switch: Testing and Inspection

IGNITION SWITCH TEST







CAUTION:
- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
- Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
- For additional precautions, refer to SRS Service Precautions







1. Remove the dashboard lower cover and knee bolster.







2. Disconnect the 5-P connector from the under-dash fuse/relay box and the 7-P connector from the main wire harness.
3. Check for continuity between the terminals in each switch position according to the table.
4. If continuity checks do not agree with the table, replace the electrical part of the switch Service and Repair