Fog Light(s) Do Not Work
July 12, 1999BULLENTIN NO.
99-014
YEAR
1996-98
MODEL
3.5RL
VIN APPLICATION
ALL
Fog Light(s) Do Not Work
SYMPTOM
One or both of the fog lights do not work when you turn them on.
PROBABLE CAUSE
The socket has an open circuit.
CORRECTIVE ACTION
Replace the bulb and socket for both fog lights.
NOTE:
At the time of this service bulletin issuance, all vehicles were produced with white sockets. If the socket is black (indicating this service bulletin has been done), the socket has already been replaced; replace only the bulb in each affected fog light.
PARTS INFORMATION
Fog Light Bulb and Socket kit: P/N 04331-SZ3-305
WARRANTY CLAIM INFORMATION
In warranty: The normal warranty applies.
Failed P/N: 34901-5Z3-000
Defect code: 032
Contention code: B01
Skill level: Repair Technician
Out of warranty: Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Technical Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1. Turn on the headlights (low beam). Turn on the fog light switch. Check for battery voltage across the terminals of the 2P connector of each affected fog light with a multimeter.
If there is battery voltage across the terminals, turn off the lights, and go to step 2. If there is no battery voltage across the terminals, do not proceed. Continue with normal troubleshooting procedures.
2. Unplug the 2P connector from an affected fog light.
3. Remove the rubber cover. Note the alignment of the cover (the word "TOP" points straight up and the drain tubes point straight down).
4. Unclip the hold-down wire, and remove the bulb and socket.
5. Replace the bulb and socket with the parts from the kit.
- If the existing socket is white, replace the bulb and the socket in both fog lights.
- If the existing socket is black, replace only the bulb. Replace the bulb in the other fog light only if it is affected.
6. Clip the hold-down wire into place.
7. Reinstall the rubber cover.
8. Plug in the 2P connector.
9. Make sure the fog lights work properly.