Main Valve Body Disassembly/Inspection/Reassembly

Disassembly/Inspection/Reassembly

NOTE:
- Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air.
- Blow out all passages.
- Replace the valve body as an assembly if any parts are worn or damaged.
- Check all valves for free movement. If any fail to slide freely, see Valve Body Repair.
- Coat all parts with ATF during assembly.
- Install the filters in the direction shown.

CAUTION: Do not use a magnet to remove the check balls; it may magnetize them.