Installation

1. Install the splash guard and tighten the screws.

NOTE: Align the projection in the splash guard with the hole on the knuckle.





2. Install the knuckle on the hub unit, and tighten the flange bolts.

3. Install the knuckle on the driveshaft outboard joint.





4. Install the knuckle on the tie-rod end, upper arm and lower arm, then tighten the castle nuts and install the new cotter pins.

CAUTION: Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by loosening.

5. Install the wheel sensor with the sensor mounting bolts.





6. Install the wheel sensor wire bracket with the two flange bolts.

NOTE: Be careful when installing the sensors to avoid twisting wires.

7. Install the caliper with the caliper bracket mounting bolts.





8. Install the brake hose bracket with the brake hose mounting bolts.

CAUTION: Be careful not to twist the hose more then necessary.

9. Install the new spindle nut, then tighten and star the nut.





10. Install the front wheel with the wheel nuts.

NOTE: Before installing the wheel, clean the mat surfaces of the brake disc and wheel.

11. Check the front wheel alignment, and adjust if necessary. Alignment