Fuse: Service and Repair

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Removal:
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
3. '95 - 96 models: Connect the short connectors (RED) to the airbag side of the connectors.

Driver's Side:
^ Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.

Under-dash Fuse/Relay Box-Removal/Installation:

^ Disconnect the 2P connector between the driver's airbag and cable reel.

Front Passenger's Side:
^ Remove the glove box.

NOTE: Before removing the glove box, remove the glove box damper.

Under-dash Fuse/Relay Box-Removal/Installation:

^ Disconnect the front passenger's airbag 3P connector from the SRS main harness, then connect the short connector (RED) to the front passenger's airbag 3P connector.

4. Remove the driver's foot rest.

Under-dash Fuse/Relay Box-Removal/Installation:

5. Remove the dashboard lower cover and knee bolster.

Under-dash Fuse/Relay Box-Removal/Installation:

6. Remove the left front door sill molding and the left kick panel.

Under-dash Fuse/Relay Box-Removal/Installation:

7. Remove the two mounting bolts, and pull the under- dash fuse/relay box away from the left kick panel.
8. Disconnect the under-dash fuse/relay box connectors, and remove the under-dash fuse/relay box.

NOTE: To disconnect the SRS main harness 2P connector from the under-dash fuse/relay box.

Installation:
1. Connect the connectors to the under-dash fuse/relay box, then install the fuse/relay box in the reverse order of removal.

NOTE: To reconnect the SRS main harness 2P connector.

2. '95 - 96 models: Reconnect the driver's airbag 2P connector to the cable reel 2P connector, and reinstall the access panel on the steering wheel.
3. '95 - 96 models: Remove and properly store the short connector (RED), then reconnect the front passenger's airbag connector (and reinstall the glove box).
4. Reconnect the battery positive cable, then the negative cable.
5. Enter the anti-theft code for the radio, then enter the customer's radio station presets.
6. Confirm that all systems work properly.