Fuel Filter: Service and Repair

Fuel Filter

Replacement

WARNING:
^ Do not smoke while working on fuel system. Keep open flame away from your work area.
^ While replacing the fuel filter, be careful to keep a safe distance between battery terminals and any tools.

The fuel filter should be replaced whenever the fuel pressure drops below the specified value [260 - 310 kPa 12.65 - 3.15 kg/cm2, 37.7 - 44.8 psi) with the fuel pressure regulator vacuum hose disconnected and pinched] after making sure that the fuel pump and the fuel pressure regulator are 0K.





1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable from the battery negative terminal.
3. Place a shop towel under and around the fuel filter.
4. Relieve fuel pressure.
5. Remove the banjo bolt and the fuel feed pipe while supporting the fuel filter with another wrench, as shown.
6. Remove the fuel filter clamp and fuel filter.
7. When assembling, use new washers as shown.
NOTE: Clean the flared joint of high pressure hoses thoroughly before reconnecting them.