Rear

REMOVAL
1. Loosen the wheel nuts slightly.
2. Raise the rear of vehicle, and support it with safety stands in the proper locations.





3. Remove the wheel nuts and rear wheel.
4. Pull the parking brake lever up.
5. Remove the hub cap.
6. Raise the locking tab on the spindle nut, then remove the nut.





7. Remove the brake hose mounting bolts.
8. Remove the caliper bracket mounting bolts and hang the caliper to one side.

CAUTION: To prevent accidental damage to the caliper or brake hose, use a short piece of wire to hang the caliper from the undercarriage.





9. Remove the 6 mm brake disc retaining screws.
10. Screw two 8 x 1.25 mm bolts into the disc to push it away from the hub.

NOTE: Turn each bolt two turns at a time to prevent cocking the disc excessively.





11. Remove the brake disc.
12. Remove the hub unit from the knuckle.

INSTALLATION
1. Install the hub unit, spindle washer and brake disc.





NOTE:
- Wash the bearing and spindle thoroughly in high flash point solvent before reassembly.
- Before installing the brake disc, clean the mating surfaces of the rear hub and brake disc.

2. Install the brake caliper with the caliper bracket mounting bolts.





3. Install the brake hose with the brake hose mounting bolts.

CAUTION: Be careful not to twist the hose more than necessary.





4. Tighten the 6 mm brake disc retaining screws.
5. Install a new spindle nut, then tighten and stake the nut.
6. Install a new hub cap.





7. Install the rear wheel with the wheel nuts.

NOTE: Before installing the wheel, clean the mating surfaces of the brake disc and wheel.