Differential Assembly Removal

REMOVAL

WARNING:
- Make sure jacks and safety stands are placed properly, and hoist brackets are attached to correct positions on the engine.
- Apply parking brake and block rear wheels so the vehicle will not roll off stands and fall on you while working under it.

CAUTION: Use fender covers to avoid damaging painted surfaces.

1. Remove the drain plug, and drain the differential oil.
2. Remove the driveshafts and intermediate shaft.





3. Remove the 36 mm sealing bolt, then disconnect the extension shaft from the differential using the special tool.

NOTE: Shift the transmission into the P position to lock the secondary gear.





4. Remove the splash shield.





5. Remove the lower plate, then reinstall the steering gearbox mounting bolts.





6. Remove the right front beam bridge.





7. Disconnect the Vehicle Speed Sensor (VSS) connector, then remove the VSS/power steering speed sensor.

NOTE: Do riot disconnect the hoses.





8. Remove the mounting bolts and 26 mm shim, then remove the differential assembly.