Set/Resume Switch Test

1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
2. Disconnect the driver's airbag and front passenger's airbag connectors.
3. Remove the dashboard lower cover.




4. Disconnect the 20P connector between the combination switch harness and main wire harness.




5. Check for continuity between the terminals of the 20P connector in each switch position according to the table.
^ If there is continuity, and it matches the table, the switch is OK.
^ If there is no continuity in any position, go to step 6.
6. Remove the steering column covers.
7. Disconnect the combination switch harness 4P connector from the cable reel.




8. Check for continuity between the terminals as shown:
^ If there is no continuity, replace the combination switch harness.
^ If there is continuity, go to step 9.




9. Remove the two screws, then remove the switch.




10. Check for continuity between the terminals in switch position according to the table.
^ If there is continuity. and it matches the table, replace the cable reel.
^ If there is no continuity in any position, replace the switch.
11. If all tests prove OK, reconnect the cable reel and combination switch harness connector. then reinstall the steering column covers.
12. Reconnect the driver's airbag and front passenger's airbag connectors, and reinstall the access panel on the steering wheel.
13. Reconnect the battery positive cable, then the negative cable.
14. After connecting the airbag connectors, confirm proper System operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about 6 seconds and then go off.