Hatch Replacement

Hatch

Replacement

NOTE:
- An assistant is helpful when removing the hatch.
- Take care not to damage the hatch and body.
- Take care not to scratch the hatch side trim and hatch trim panel.
- Open the hatch.
- Remove the high mount brake light.




1. Remove the hatch side trim on each side.




2. Remove the hatch trim panel.






NOTE: Detach the clips by sliding the hatch trim panel forward, then remove it.

3. Remove the hatch spoiler as described on page 20-161 (if so equipped).




4. Disconnect the connectors, then remove the wire harnesses from the hatch.
5. Remove the rear wiper motor.
6. Remove the upper anchor bolts from the front and rear seat belts , then remove the upper portion of the quarter pillar trim panel.
7. Remove the rear roof trim, then pull the rear of the headliner down.

NOTE: Take care not to bend the headliner.

8. Remove the support strut on each side while holding the hatch.






NOTE: Do not raise the hatch too far; the corners of the glass may hit the roof and break.




9. Remove the nuts, then remove the hatch.






NOTE: If necessary, replace the support strut.




- If necessary, remove the hatch hinge.

10. Installation is the reverse of the removal procedure.

NOTE:
- If necessary, replace any damaged clips.
- Make sure the connectors are connected properly.
- Make sure the hatch locks securely.
- Make sure the hatch opens properly.
- Adjust the hatch alignment.