Gauge Assembly Removal and Installation

GAUGE ASSEMBLY / REMOVAL







CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.

Whenever the ignition switch is ON, or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

1. Remove the two screws from the instrument panel.







2. Remove the instrument panel.

NOTE: Remove the instrument panel carefully without damaging the clips.

3. Tilt the steering wheel down with the tilt adjustment lever.







4. Remove the three mounting screws, and spread a protective cloth on the steering column.







5. Pry the gauge assembly out, and disconnect all connectors from it.







6. Take out the gauge assembly as shown.