Alarm Module: Testing and Inspection

Remove the glove box, and disconnect the 22P connector and 16P connector from the control unit.

Inspect the connector and socket terminals to be sure they are all making good contact.

Control Unit Input Test:

- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, make the following input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty: replace it.
- Different wires with the same color have been given a number suffix to distinguish them (for example, YEL/GRN1 and YEL/GRN2 are not the same).