Initializing the OPDS Unit

When the seat-back cover or seat-back cushion assembly are replaced with new one, initialize the OPDS unit links with the OPDS sensor by following the procedure below.

NOTE: Set the seat-back in the normal position, and make sure there is nothing setting on the front passenger's seat.

1. Make sure the ignition switch is OFF.
2. Connect the SCS service connector to the service check connector (2P). Do not use a jumper wire.




3. Connect the SCS service connector to the MES connector (2P). Do not use a jumper wire.
4. Turn the ignition switch ON (II).
5. The SRS indicator light comes on for about six seconds and goes off. Remove the SCS service connector from the MES connector within four seconds after the SRS indicator light went off.
6. The SRS indicator light comes on again. Reconnect the SCS service connector to the MES connector within the four seconds after the SRS indicator light comes on.
7. The SRS indicator light goes off. Remove the SCS service connector from the MES connector within four seconds.
8. The SRS indicator light indicates that the OPDS unit is initialized by blinking two times, then going off.
- If the light doesn't blink two times and stays on, repeat this procedure beginning with step 1.
- If the light stays on after blinking two times, read the DTC and proceed with the troubleshooting.
9. Turn the ignition switch OFF, and wait for ten seconds.




Turn the ignition switch ON (II) again after the procedure. The SRS indicator light comes on for about six seconds and goes off, and then if the SRS indicator light doesn't come on again after 30 seconds, the initialization of the OPDS unit is complete and the system is OK.