Transmission Position Sensor/Switch: Service and Repair
A/T Gear Position Switch Replacement1. Raise the front of the vehicle, and make sure it is securely supported.
2. Set the parking brake, and block both rear wheels securely.
3. Shift to the [N] position.
4. Remove the A/T gear position switch connector (A) from the connector bracket (B), then disconnect the connector.
5. Remove the clamp from the harness clamp bracket on the transmission housing, and remove the harness clamp (A) from the end cover (B).
6. Remove the A/T gear position switch cover (C), then remove the A/T gear position switch (D) from the end cover.
7. Set the A/T gear position switch to the [N] position.
NOTE: The A/T gear position switch clicks in the [N] position.
8. Set the control shaft to the [N] position.
9. Install the A/T gear position switch (A) gently on the control shaft (B), then secure it with the bolts.
NOTE: Take care not to move the A/T gear position switch when tightening the bolts.
10. Install the A/T gear position switch cover (C), and the harness clamp (D) on the end cover (E).
11. Connect the A/T gear position switch connector (A), then install it on the connector bracket (B).
12. Turn the ignition switch ON (II). Move the shift lever through all gears, and check the A/T gear position switch synchronization with the A/T gear position indicator.
13. Start the engine. Move the shift lever through all gears, and verify the following:
- The engine will not start in any position other than [N] or [P].
- The back-up lights come on when the shift lever is in the [R] position.