Impact Sensor: Service and Repair
Side Impact Sensor ReplacementRemoval
NOTE:
- Removal of the side impact sensor must be performed according to the precautions/procedures described previously.
- Before disconnecting the side impact sensor 4P connector(s), disconnect the side airbag 2P connector(s).
- Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the seat assembly.
3. Remove the front door sill trim.
4. Remove the center pillar lower trim panel.
5. Remove the lower anchor bolt.
6. Turn up the carpet (A), then disconnect the SRS floor harness 4P connector from the side impact sensor.
7. Remove the two Torx bolts (A) using a Torx T30 bit, then remove the side impact sensor (B).
Installation
NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Install the new side impact sensor with Torx bolts (A) then connect SRS floor harness 4P connector (B) to the side impact sensor (C).
2. Reinstall the plate.
3. Reconnect the battery negative cable.
4. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.