Without Scan Tool

Special Tools Required: SCS Service Connector 07PAZ - 0010100




1. Turn the ignition switch OFF, and wait for ten seconds. Then connect the SCS short connector to the service check connector (2P). If you don't wait ten seconds, the SRS unit won't be completely reset or output DTCs.
2. Turn the ignition switch ON (II). The SRS indicator light comes on for about six seconds, and then goes off. Then it will indicate the DTC.

Reading The DTC:

- Including the most recent problem, up to three different malfunctions can be indicated (see example 1 in fig).
- In case of a continuous failure, the DTC will be indicated repeatedly (see example 1 in fig).
- In case of an intermittent failure, the SRS indicator light will indicate the DTC one time, then it will stay on (see example 2 in fig).
- If both a continuous and an intermittent failure occur, both DTCs will be indicated as continuous failures.
- When the system is normal (no DTC), the SRS indicator light will stay on (see example 3 in fig).
- If the SRS indicator light comes on continuously without any DTCs, there may be a problem in the light circuit.

Pattern Of The DTC Indications:

3. Read the DTC.
4. Turn the ignition switch OFF, and wait for ten seconds. Then disconnect the SCS short connector from the service check connector (2P).