P1676

DTC P1676: FPTDR Signal Line Failure - A/T Model

1. Reset the PCM.
2. Start the engine and wait 10 seconds.

Is DTC P1676 indicated?

YES - Go to step 3.

NO - Intermittent failure system is OK at this time. Check for poor connections or loose wires at the ABS/TCS control unit and at the PCM.

3. Turn the ignition switch OFF.
4. Disconnect PCM connector E (20P) and the ABS/TCS control unit 16P connector.




5. Check for continuity between body ground and PCM connector terminal E16.

Is there continuity?

YES - Repair short in the wire between the ABS/TCS control unit and the PCM (E16).

NO - Go to step 6.




6. Check for continuity between ABS/TCS control unit 16P connector terminal No.1 and PCM connector terminal E16.

Is there continuity?

YES - Go to step 7.

NO - Repair open in the wire between the ABS/TCS control unit and the PCM (E16).

7. Reconnect PCM connector E (20P).




8. Connect PCM connector terminals E16 and C28 with a jumper wire.
9. Reset the PCM.
10. Start the engine and wait 60 seconds.

Is DTC P1678 indicated?

YES - Substitute a known-good ABS/TCS control unit and recheck. If the symptom/indication goes away, replace the original ABS/TCS control unit.

NO - Substitute a known-good PCM and recheck. If the symptom/indication goes away, replace the original PCM.