Rear

Replacement
1. Raise the rear of the vehicle, and make sure it is securely supported. Remove the rear wheels.





2. Remove the flange nuts (A) while holding the respective joint pins (B) with a hex wrench (C), and disconnect the stabilizer links (D) from the stabilizer bar (E) on the right and left of the vehicle.





3. Remove the flange bolts (A) and bushing holders (B), then remove the bushings (C) and the stabilizer bar (D).





4. Install the stabilizer bar in the reverse order of removal, and note these items:
^ Use new self-locking nuts on reassembly.
^ Note the right and left ends direction of the stabilizer bar.
^ Make sure the paint mark (A) faces downward.
^ Refer to Stabilizer Link Replacement to connect the stabilizer bar to the links.