Countershaft Disassembly, Inspection, and Reassembly

Disassembly, Inspection, and Reassembly
1. Remove the locknut, and take off components down to the reverse selector hub.
2. Remove the reverse selector hub, 4th gear, and 1st gear.
3. Check the bearing on the 3rd clutch for wear and rough movement. If the bearing is worn or damaged, replace it.
4. Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
5. Check the splines for excessive wear and damage.
6. Check the shaft bearing surfaces for scoring and excessive wear.
7. Lubricate all parts with ATF, and reassemble the shafts and gears.
8. Install the distance collars, reverse selector hub, reverse selector, splined washer, and conical spring washer in the direction shown.