Engine Installation

Install the engine in the reverse order of removal. Reinstall the mount bolts/nuts in the following sequence. Failure to follow these procedures may cause excessive noise and vibration, and reduce bushing life.

Automatic Transaxle:

Manual Transaxle:

1. Install the transmission mount, then tighten the bolt/nuts on the transmission side. Leave the mount bolt loose.





2. Install the engine side mount, then tighten the bolt/nuts on the engine side. Leave the mount bolt loose.

Automatic Transaxle:

Manual Transaxle:

3. Tighten the mount bolt on the transmission mount.





4. Tighten the mount bolt on the side engine mount.





5. Install the rear mount bracket, then tighten the bolts in the numbered sequence shown ((1) - (3)).

Automatic Transaxle:

Manual Transaxle:

6. Install the right front mount/bracket, then tighten the bolts in the numbered sequence shown ((1) - (2)).





7. Install the led front mount, then tighten the bolts in the numbered sequence shown ((1) - (3)).
- Check that the spring clip on the end of each driveshaft clicks into place.

CAUTION: Use new spring clips.

- Bleed air from the cooling system at the heater valve open.
- Adjust the throttle cable.
- Check the clutch pedal free play.
- Check that the transmission shifts into gear smoothly.
- Adjust the tension of the following drive belts.
Alternator belt.
P/S pump belt.
A/C compressor belt.
- Inspect for fuel leakage.
- After assembling fuel line parts, turn on the ignition switch (do not operate the starter) so that the fuel pump operates for approximately two seconds and the fuel line pressurizes. Repeat this operation two or three times and check for fuel leakage at any point in the fuel line.