Fuel Tank: Service and Repair

WARNING:
- Do not smoke while working on fuel system. Keep open flame away from your work area.
- Make sure lifts are placed properly (see General Information).




1. Raise the vehicle.
2. Remove the drain bolt, and drain the fuel into an approved container.
3. Remove the center rod (see Engine).
4. Disconnect the M/T shift cable and M/T clutch cable or A/T shift cable from the transmission (see Automatic Transmission).
5. Remove the bulkhead panels and access panel.
6. Disconnect the C486 (6P) connector.
7. Disconnect the hoses. Slide back the clamps, then twist the hoses as you pull, to avoid damaging them.
8. Place a jack, or other support, under the tank.
9. Remove the strap bolts and nuts, and let the straps fall free.
10. Remove the fuel tank. If it sticks on the undercoat applied to its mount, carefully pry it off the mount.
11. Install a new washer on the drain bolt, then install parts in the reverse order of removal.