Exterior Moulding / Trim: Service and Repair

Roof Drip and Rear Pillar Moldings Replacement

NOTE: Put on gloves to protect your hands.




1. Remove the screw from the front edge of the roof drip molding. Detach the moldings from each clip, then remove the roof drip molding (A) and rear pillar molding (B) as an assembly. Take care not to scratch the body.
2. Separate the roof drip molding and rear pillar molding.




3. Install the moldings in the reverse order of removal, and note these items:
- After joining the rear pillar molding (B) with the roof drip molding (A), lightly tap the locking tabs (C).
- Replace any damaged clips.